ANKER PowerPort Speed 5 Ports Holder

ANKER PowerPort Speed - 5 Port - Holder\Mount

This is a holder I made for the Anker PowerPort Speed 5 Ports which sits behind my TV unit. The hook is added so it can hang off the back of the unit from a cut out which the cables run through.

I've included a model without the hook so this can be amended to other mounts or fixtures e.g. CommandStrips.

Printing Notes

I found printing from this angle worked quite well with the supports coming off quite easily. A high infill would be advised, it will take longer but obviously stronger. Test prints with less infill made removing the supports from the rounded edges slightly tricky but not too hard.