Pocket Door Strike with Latch Receiver

A pocket door strike with latch receiver, since I could not find any that were not part of packs with new latches.

FreeCAD and OBJ files included for customization. Screw holes sized for drywall screws (1-1/4" x 6) since I had those already. May need adjusted for other screw types. Also check your tolerances for your pocket door latch.

PLA should work, but I used PETG with 40% infill and was very happy with the strength.

Print instructions

Category: Replacement Parts Summary

A pocket door strike with latch receiver, since I could not find any that were not part of packs with new latches.

FreeCAD and OBJ files included for customization. Screw holes sized for drywall screws (1-1/4" x 6) since I had those already. May need adjusted for other screw types. Also check your tolerances for your pocket door latch.

PLA should work, but I used PETG with 40% infill and was very happy with the strength.

Print Settings

Printer Brand: Prusa

Printer: I3 MK3S

Rafts: Doesn't Matter

Supports: Doesn't Matter

Resolution: 0.2mm

Infill: 40

Filament: Amazon Basics PETG