Low Profile Ryobi 40v Leaf Blower Wall Mount

Designed a low profile holder for the Ryobi 40v Leaf Blower. The dovetails are loosely fit into the injection mold cavity and the wall mount is slid over them. Afterwards, the dovetails glued in place to get the fit right, I used CA glue then hot glue. You may need to lightly sand the front of the wall mount so the dovetails slide smoothly. I made this a tight tolerance knowing that I wanted a snug fit.

Here's a gif of how easy it should slide on

https://gfycat.com/easygoingdecentindianpangolin