Skadis Mount Voltcraft VC135 Multimeter

modeled from scratch, but highly inspired by https://www.printables.com/model/361590-multimeter-halter-voltcraft-ikea-skadis - so all credits to him.

Since this is my first upload, I hope the category is the correct one.

I printed the original version first, without really paying attention to the correct model of the multimeter in the picture - of course, it didn't fit, cause I had one version bigger.

I searched a bit if there is any mount for this particular model out there, without success, so I decided to create my own. Since I am very bad with altering existing models, I decided to create a "new" one, but closely follow the design patterns of the original

One thing I wanted to improve were the hooks, and my actual first prototype came out perfectly, so I decided to keep it as it is.

Print settings I used and recommend (I printed in PLA because I thought I'd need to print multiple more, but I strongly suggest PETG for anything pegboard related)

Layer Height: 0.2mm (probably works with 0.3 as well, but didn't test)

Perimeters: 3

Infill 30% - I think 20% is sufficient, but wouldn't go lower.

Supports: everywhere (for the hooks)

Print time around 4h

Since it's my first upload, any feedback will be appreciated even more than usual :)