Wireless Corne Choc Version

The case is for a wireless corne board found here . pick choc version to fit this case.

The Idea came from the Mx version of this case that I made here

This case has:

- Specific holes cut for the switch and reset button - Extended switch and reset buttons - Recessed holes to fit the head of an M2 bolts even the short ones included in typeractives fr4 plate kit I still have some plans moving forward with this case, I will most likely either be updating it or making a v2 including some way of covering the nice nano or integrating a nice view into it.

I print the case out of PLA solid by increasing the bottom layers in my slicer to the number of layers the case is at .2 mm 90 layers. Once you have printed the case, button, and switch you can install them. Make sure the flat side of the button is facing down, as it came off of the bed. Then add either M2 bolts, standoffs, and a 3D printed plate or use the included hardware from Typeractive's fr4 case set found here .