Vsett 10+ Front Fender Spacers

Opened up a brand new Vsett 10+R today, filled the tires with armor-dilloz and then inflated to 45 psi and would ya look at that… the front fender started rubbing on the tire.

Of course, you can simply use a handful of washers to fix this issue, but obviously to the printer I ran! Printed from Prusa PC Blend w/ 6 top and bottom layers, 4 walls and 40% gyroid infill to ensure strength, but that is honestly likely pretty overboard.

If you wish to raise the front fender even higher you can print multiple or simply stretch the Z height in your slicer (may require longer SHCS). One set worked perfectly for me and was still thin enough that the stock M4x10 SHCS threaded back in with more than enough engagement.