Flashforge Creator Pro 2016 Spool Holder Hole Plug

I switched some time ago away from the spool holders at the back of the printer, because they are high friction compared to having a spool holder that runs on skateboard bearings. That leaves the old spool holders hanging off the back of the printer.

This thing allows you to remove the old holders and plug the gap where they attach to the Flashforge Creator Pro 2016, stopping dust/cold air etc getting into the back of your printer.

It is push-fit and was designed to be printed with flexible filament without supports.

Print Settings

Printer Brand:

FlashForge

Printer:

Creator Pro

Rafts:

No

Supports:

No

Infill:

20%

Notes:

This object should be printed with flexible filament. I recommend Ninjaflex SemiFlex as it is the only filament I have tried that prints reliably without any mods to the extruder.