Voron V2.4 Frame Stabilisers UPDATED

This is a remix of my frame stabiliser for the Voron V0 now made to fit the Voron 2.4 frame size.

I have beefed it up to add extra rigidity as the frame size is much larger than the V0.

But still keeps a small form factor to sit neatly in the corners of your frame.

This is now availible in two sizes…

V1 = 97mm long (original)

V2 = 124mm long (new)

Print with the usual Voron Settings for best results

4 x perimeter

5 top and bottom

40% infill

ABS / ASA is recommended if printing in an enclosure

After some feedback i have made the fixing holes a little larger as they were a bit on the snug side

Any feedback on this design will be very welcome!

As always, happy printing and don't forget to upload your make!