Working Nintendo Switch Lite Charging Dock

Nintendo Switch lite dock for charging only. Your Switch Lite will NEVER be able to connect to the TV.

Print Settings

- layer height - .2 (Doesn't matter) - Nozzle Diameter - ≤ .4 (Logo will not Work above .4) - Infill - If you can do a higher infill to make it heavier How to Assemble

First off you will need a USB-C charger like for your phone (NOTE: Official Nintendo chargers will not work for this.)

After you print out the 2 pieces you will need to put to charger cord through the slot than close the 2 pieces together. it should be a good fit but may be a bit loose so some Superglue should do the trick. The fit for the cord will probably be a bit loose (In case of varying sizes of the charger). Again some Superglue should hold it in Place.