Anycubic i3 Mega housing for 12864 LCD Graphic Smart Display Controller Board

This is a housing which can be used to mount a "12864 LCD Graphic Smart Display Controller Board" to an Anycubic i3 Mega.

BOM:

- 4x M3 5mm screw, 4x M3 washer (to mount the holders) - 4x M3 10mm screw (to mount the screen) - 2x M4 12mm screw, 2x M4 washer, 2x M4 nut (to mount the housing to the holders) I won't provide an adjusted firmware to make this display operational with an Anycubic i3 Mega/S!

Print instructions

Print Settings

- Infill: 20% - Support: no - Perimeters: 6 - Extrusion width: 0.45 - Layer height: 0.2, 1mm top/bottom thickness - Filament: PETG, ASA, ABS Post-Printing

Rework the 4mm holes of the holders To make the holes printable without using any supports, I closed them with a 0.2mm thin layer. Just use a screwdriver/knife or a 4mm drill to open them entirely again.