StandBy/Nightstand Mode MagSafe iPhone and Apple Watch Stand

Update: 09/23/2023 Added V2 models that are more streamlined. I'd like to think they use less plastic but I haven't measured. Same instructions as below regarding which model to pick based on which Apple Watch charger you have.

iOS17 has a StandBy setting, aka “Nightstand Mode”, where a different display is shown when the iPhone is attached to the MagSafe charger and is in landscape orientation. This stand was designed around this new mode and also adds an Apple Watch charger. There are two versions depending on which Apple Watch charger you have. If the Apple Watch charger has a depth of ~8mm, please use the 8mm version. If the Apple Watch charger has a depth of ~6mm, please use the 6mm version.

This was printed on a Prusa mk3s. There is very little tolerance in the spots where the chargers fit and the cord tracks as I didn't want them to come loose. Feel free to scale the model if your charger(s) do not fit. I recommend at least 0.15 resolution and whatever infill you want. Print it upright as shown in the pictures. No supports!

Both charger cords should be fed into the stand from the front and then guided down the channels. The watch cord should be fed through the back channel and the phone cord should be fed through the front channel. The cord channels on the bottom of the stand are different sizes because the cords are different sizes. The phone cord should be routed directly down the smaller middle channel and the watch cord in the larger channel that is offset from the middle.