Sanding Block Holder (Pegboard)

This holds my sanding blocks of 3 different grits. The sandpaper is attached to the block with spray adhesive. The blocks measure 2.75in x 4.5in x ¾in (69.85mm x 114.3mm x 19.05mm).

I use this with standard 1" pegboard, but I left the back empty for you to add your preferred mounting option if desired. I use a generic pegboard plate to superglue onto the back wall of the model, this allows me to get the alignment right without precise measurements during the modeling process. Put superglue onto the plate, put the plate up on your pegboard, then press the model onto the plate.