QUICK-CLIP : Belt Loop Buckles

NOTE: This is an add-on to the pre-existing "QUICK-CLIP : Base Starter Kit"

Post-Processing Difficulty: Easy (Ready to Use from Printer)

Tools Needed: None

Introduction & Instructions:

QUICK-CLIP is a versatile mounting system that I designed for backpack and MOLLE webbing. This is a belt loop buckle (with different versions to fit 30mm, 35mm, and 40mm wide belts) that I designed to go with the base starter set (found under my profile). Modules are attached and removed from the buckles in the same way as the original ones.

The buckles can be printed with no supports or brims in the upright orientation of the .stl files. Once printed, they can be worn on your belt in either orientation.

Hope you enjoy!