MagSafe Charging Mount for Cooler Master Qube 500 Case

This sleek MagSafe mount is designed to perfectly mount your iPhone to the front of your Cooler Master Qube 500 Case.

Any MagSafe charger with a three foot cable will be able to reach the Qube 500 PC Case's rear I/O allowing charging whenever the PC is on when routed under the case as shown in the renderings.

Print Settings:

Orientation: The model has been pre-orientated so that it is at its ideal printing position.

Supports: Two small supports are necessary to support the bottom portion of each case clip. I left built-in supports off of the model as I know many users have different preferences but the supports are required. Other supports may be required in a few areas if your printer does not handle overhangs well however most Prusa and Creality machines will handle these fine.

Infill/Material/Quality Settings: Up to you! The design does not require very specific slicer settings with the exception of supports.