DUMMY 13 goes to COMIC CON - Scout Trooper V1.0

Based on DUMMY 13 Beta - Oct. 2023

DUMMY 13 Printable Jointed Figure © 2023 by Lucky 13 Toys is licensed under CC BY 4.0

Get your Dummy 13 here: /model/593185

DUMMY 13 loves COMIC CON!

So I have started to design a whole series of characters and costumes for DUMMY 13. This is another costume from the series "DUMMY13 goes to COMIC CON".

The aim is to preserve the charm and simplicity of Dummy 13.

Content of ScoutDUMM , sorry Scout Trooper:

- Helmet to use with an original black head - Long-range scout weapon, as known from the original trilogy - (Optional) Speeder - Other parts are standard parts that are just printed in different colors (see pictures) Get more:

- More outfits /@Mici/collections/967681 - More weapons /@Mici/collections/1103020 - More hands /@Mici/collections/1103017 Add-on:

Are you tired of walking through the jungle? Get your speeder here: /model/683272

Rifle hands: /model/656046

You need more weapons? Have a look at MyStoopidStuff 's fantastic Star Wars - Weapons Pack: /model/721487

Printing:

Layer height Brim Supports

Helmet 0.15mm x x (Below the ears and on the upper edge of the eyes)

Weapon 0.15mm for details - -

Assembly:

Helmet:

Slide the head into the Helmet and press it in with gentle force on the chin.

If this is not possible, it is probably due to the following points:

- Check the inside of the helmet (mostly the top and behind the eyes) to see if it has been printed cleanly and remove any filament debris that is sticking out - Has the brim been removed cleanly? - The elephant foot can cause the inner rim to be a little too narrow, just sand the inner rim down a little or work it with a knife