FUNKO Hexagon Display

These models will allow you to display Funko POPs , Funko Sodas, as well as Cards that are placed in Top loaders.

The Hex Big Shelf will support a Standard 4" Funko POP that are also in Funko Protectors.

The Hex Small Shelf will support a Funko Soda Can or any Loose Funko Figures.

I also created some Hexagon “Fillers” to allow you to create a display on the wall and not look too clustered. These include a FUNKO Logo, a POP! Logo, and a Hexagon that you can slide a Top Loader into.

NOTE: Due to the size of my printer bed I wasn't able to make Hexagons that would allow you to comfortably stack the Normal size Funkos, But this is why I created the “Fillers” and the Small Shelf. Refer to my Photos to see what im referring to.

I attached them to the wall with 2 screws each.

I printed the infill at 20% which seemed to be plenty strong to support the Funkos.

Im sure you could go even less than 20% on the fillers to save time.

****UPDATE****

1/19/2024 - ADDED A TMNT AND STAR WARS SHELF