IKEA Skadis Apple watch charger holder

This is Apple Watch charger holder for IKEA Skadis pegboard. Made for USB-C Apple Watch charger.

Prints without supports.

This item is inspired by IKEA SKADIS Collection by CSD Salzburg, it uses the same hook system (I included the hook).

Check out the collection of other IKEA Skadis holders I made .

How to put charger into the holder:

- Put charger wire into the hole:

- Snap the wire into the wire holder:

- Pull the wire until the charger pad near its place:

- Push the charger pad in: How to remove charger from the holder: just push out the charger pad from below through the center hole.