Sovol SV06 Plus extruder mounted cable support

Keep your Sovol SV06 or SV06 Plus extruder cable elevated with this cable support!

This model was created in OpenSCAD . The default curve angle of 60° is customizable in the OpenSCAD model.

Recommended pairing

This model pairs well with my mainboard box-mounted extruder cable support (remix) .

Printing

This prints on its side. A brim may be useful for bed adhesion.

Installation

Remove the extruder cable from the clips on top of the extruder housing. Slide the support onto the clips, and then reinstall the extruder cable into the clips on top of the support. Fasten the cable to the support at the curve with a zip tie.