DUMMY 13 goes to COMIC CON - Locutus of borg V1.0

20. Mar. 2024 V1.0:

- First release

Based on DUMMY 13 Beta - Oct. 2023

DUMMY 13 Printable Jointed Figure © 2023 by Lucky 13 Toys is licensed under CC BY 4.0

Get your Dummy 13 here: /model/593185

DUMMY 13 loves COMIC CON!

So I have started to design a whole series of characters and costumes for DUMMY 13. This is another character from the series "DUMMY13 goes to COMIC CON".

The aim is to preserve the charm and simplicity of Dummy 13.

Get more: /@Mici/collections

----------------------------------------------------------------------------------------------------------------

Content of Locutus of DUMM , sorry Locutus of borg:

- Mask - Head laser mount - Armor - Hand Printing:

Please double check the provided 3MF file (Prusa Slicer).

Layer height Brim Supports

Mask 0.10mm - -

Laser mount 0.10mm - -

Armor 0.15mm - -

Chest lower part 0.15mm - -

Hand (PETG) 0.15mm - -

Assembly:

Check and widen all holes with a piece of filament.

- Mask: - Use a piece of TPU filament - Put on the laser holder - Push the end of the filament into the hole in the mask - Do not go too far. The inside of the mask MUST remain flat - Glue the mask to the head - Glue the laser holder onto the mask - Insert the other end of the filament into the back of the armor. - Use a piece of red filament as laser

- Armor - Use two pieces of TPU filament and connect the two holes on the armor with the two holes on the lower chest - Use the length that gives you the best look - You will need tweezers - Use glue if necessary