BTT HDMI5 v1.1 Screen Mount for Tenlog TL-D3 or 151mm hole mount

An external mount for BTT HDMI5 v1.1 screen for a Tenlog TL-D3 printer/ a surface with two screw holes 151mm apart, 35 degrees canted from the surface.

You can use the original screws for the Tenlog TL-D3 to mount this. This sits over the OEM Screen.

My screen is running off of a BTT Pi v1.2 as the MCU, which is connected to an Octopus Pro v1.1 main board. If you are using a standard Tenlog Board, make sure you can use the connections before assuming that just because I did, that you will be able to, too.