Ender 3 v3 SE/KE Right Side Setup (Nebula Pad / display, tools, bin)

My printer setup is turned 90 degrees, facing left, to avoid taking too much space into the room (the bed moves right to left). Having the screen face left is unnecessary, and for Nebula Pad (same as KE display), having USB on the right side, even counter-productive, since it protrudes far outside the printer and will be the first damaged part. So I've modified the Nebula Pad / display mount to face right, modified the Nebula Cam mount to fit on the X-rail, and created a tool mount to sit to the right of the gantry. Sharing the result for any people with the same printer setup direction. You can see what it looks like in the pics.

No support needed, 15% infill.

Instructions for assembly:

- Disconnect the cable from the Nebula Pad, mount the pad holder and put in the pad to the very bottom - Pull the display cable out as far as possible from the printer chassis - its whole length will be needed. - Route the cable according to the pictures below - it has to pass over the bolts and into the dedicated slot in the upper corner, above the bolt. It also has to be flat all the way. And then it arrives to the right spot, completely stretched but without force: I'm also going to buy a spring USB cable for Nebula Pad and create a cable holder on the cam and near the screen to support it - so it might come in the future. [edit] Eventually the spring cable didn't need any holders, it just comes out of the top USB and the stretch doesn't create enough force to justify a special holder.