Lego 12 Minfigure Hex Stand

I designed this hexagon-based stand to display a full set of 12 Lego collectible minifigures. There's space around each minifig to display the various accessories that often accompany these collectibles. Printed with Polymaker PolyTerra PLA using my Creality Ender 3 v2 with a 0.20 mm layer height and a 0.4 mm nozzle. Infill was set to 15% cubic.

A few of the studs were slightly too tight of a fit, so after printing, I took a 1x1 Lego brick and twisted it on and off of those studs to smooth them down a bit.