Logitech C270 Mount for Prusa MK4

I used a version of In3DSpace's C270 mount on my MK3S+. After upgrading to a MK4, I wanted to mount my camera similarily. Rokkdaddy's C270 mount had the correct look to fit with the MK4 X-motor mount, but too long arm for my use (my enclosure's pocket doors would have hit the camera). So, I decided to spend way too long to mash the two different mounts together, and then rework the camera end for a tighter grip (to avoid the camera drooping too easily).

Same hardware needs as In3DSpace's version:

- 1x M3x18 screw for attaching the mount to the X-motor. - 1x M3x25 screw for attaching the camera to the mount. The tighter camera grip is quite tight, so in case that's not working for you, I included a version with the camera end left as is in In3DSpace's original model.

Changelog

- 2024-07-02 - Shorten arm by about 1.6mm, bringing it closer to the stated 89mm length (for the unmodified camera end, the total length is exactly 89mm, my modified camera end adds 0.77mm). I mainly did this because I needed to shave off a little length to fit properly in my enclosure, but it had the added bonus of simplifying the Fusion 360 source.