Planter #2 - Kumiko Hemp Leaf using a split design, multi-material (AMS)

Planter with a simple split design for multi-material printing and 2 holder plates.

Two different filaments are used, a Marble PLA and a black PLA.

Two different patterns for the upper part of the pots are used:

1- Kumiko Hemp Leaf

2- Angled slash

Two different Plates/bases are provided:

1- Rectangular double base

2- Circular single base.

Planters with drainage as well as non-drainage designs are provided.

The pots have been tested with water over a 24 hr. period and did not leak, but these are PLA so will eventually swell and/or leak over extended usage. An epoxy or other sealant would not be a bad idea.

The planters are 80 mm height x 90 Width.

With the base, 85 mm height with a 200mm wide base.

No supports required.

The slicer settings for the base(s) and planters themselves:

Sunlu PLA+ Marble

Eryone PLA Matte Black

The slicer settings for the plater/pots and circular base:

.20 mm Strength Infill % - 100 , Rect Wall Loops - 8 Top Shell - 8 Bottom Shell - 8 Seam: Random

The slicer settings for the rectangular base:

.20 mm Strength Infill % - 100 , Rect Wall Loops - 8 Top Shell - 8 Bottom Shell - 8 Seam: Aligned