The Nautilus + LED strip - Sovol SV06 PLUS Fan Duct 5015

There are already many iterations of the very popular Nautilus, so I won't be adding much but the links to the sources with all the information you need.

The only differences from the other links are:

- The lengths of the screws used for the nautilus, in my case I needed 26mm countersunk screws , they just go straight through plastic until they reach the thread on the front side of the extruder, not interfering with the extruder board. (this seems to be the case with the PLUS model)

- The Mosfet I used was different from the one used by @Beau Slim, but achieved the same result. And eventually changed it to be controlled by the Raspberry Pi running the printer, instead of the pins (PA13/14) in the Printer's MCU Original The Nautilus by @Leander Perez Blanco PLUS Version by @3DRibo LED Version by @Jonybat Mosfet instalation adapted for the LED by @Beau Slim