Thrustmaster Sparco Button Box HAT switch

update: added a second version including some small directional indicators just to make it a little easier to tell if you're pushing it up/down/left/right

made this small replacement hat switch knob for my thrustmaster sparco P310 steering wheel, found the original a little awkward to use so wanted a normal HAT switch style knob, like seen on a flight stick, i also added a small hole for a M2x4mm cap head screw to be inserted into the side to interface with the flat side of the hat switch post to stop it twisting around.

reccomend printing with at least a 0.4mm nozzle at 0.1mm layer height or smaller nozzle if possible, and will most likely need to use a 2mm drill bit to clean the main hole in order to slide over the post, if using the m2 screw to secure it perhaps a bigger drill bit could be used to make it slide on and off much easier while allowing it to still be snug on the switch