Raspberry Pi v2 Camera Mount for Octoprint

Another redesign of my Camera Mount. My last one I did not like how the ribbon sat so time for a re-design

You will need the extended ribbon cable

There are two designs, one with the ribbon cutout in the side and the other where you can feed the ribbon out the bottom.

Print Settings

Printer Brand:

Wanhao

Printer: Wanhao Duplicator i3 V2

**Rafts:**

No

Supports: Yes

**Infill:**

15-20%

Notes:

Make sure you print supports on the top lid

Category: 3D Printer Accessories