Barrina T8 LED Light Magnetic Hanger / Clip

This is a magnetic clip / holder for Barrina T8 LED lights. There are 2 models one fits 20x3mm and other fits 36x7mm . I found for 8ft lights the 20x3mm wasn't quite robust enough for my use, but could be used by someone.

My shop has steel studs across the ceiling that are very difficult to drill into. I have been using duct tape to tape the lights to the ceiling studs. They fall down every few months 🤣 I have tried magnets but they don't adhere well to the aluminum back of the lights.

The clip will slide over the endcap of the light and then slide freely along the light. If using the 36x7mm magnets linked here there's a hole for a screw and I used a short screw to set the clips at the location I needed.