Ender 3 v2 40mm Riser Feet

Ender 3 v2 40mm riser feet. This is a remix of https://www.thingiverse.com/thing:4789307

These feet are higher at 40mm lift, while keeping the inside profile flat so all drop down fan mods to the mainboard and PSU still all fit.

They are a straight fit to stock Ender 3 v2, have cut outs for the rear screws and plate area.

Bottom outside of the feet flare out to provide are bigger overall footprint of the printer for better stability.

The have a 2mm insert on the bottom of each foot, no longer take the stock ender rubber feet, instead use 3-4mm rubber matting cut to size with double side tape to fix.

Printed standing up at 0.2mm layer height 40% grid infill keeps them solid Use NORMAL support 'touching everywhere' Supports needed for 2mm insert underneath and the rail guides, both come off clean and easy.