Alesis Nitro Pro Electronic Drum Set Drumstick Holder and Drum Key Holder

Needed to make a few minor improvements to my Alesis Nitro Pro Drum set. I needed a place to put drumsticks that were readily accessible, and at the same time wanted a place to keep the drum key from being lost. Came up with this design that has worked well. It may work for other drum or electronic drum sets as well if the frame is the same diameter. This design will require a single small nut and bolt which can be picked up from most any hardware store.

There are several options here. A drumstick holder with several drum key mount points, a bare drumstick holder and a drum key holder that can be super glued to any part of the tube you wish so the key holder is exactly where you want it.

I printed it upside down with tree supports down the middle, but I'm sure it could be printed upright as well with tree supports. I lined mine on the inside with a felt material so the sticks wouldn't rattle, and it's worked out quite well. Spare sticks are always right at arms reach without having to dig into a hanging bag.

If you have a Nitro Mesh or other set with smaller frame diameters, you may be able to use this persons design to adapt it over: https://www.thingiverse.com/thing:5853976

For the same Alesis Nitro Drum Kit, I also made a small piece to limit the back travel of the kick so it would stop bouncing off the top of my foot (https://www.thingiverse.com/thing:7093662) and a headphone holder. (https://www.thingiverse.com/thing:7093652)