KLR650 Gen 2 Aftermarket Turn Signal Adapters

KLR650 Gen 2 Turn signal adapters. These fit into the holes in the fairing for the OEM signal stalks and allow mounting aftermarket signals that use a standard post type design. I printed the outer piece in TPU and the inner in PETG. Also would work fine with PETG for both. I printed with 100% infill. They're small, so no point in trying to save a few grams of filament. Two versions are for different size aftermarket signal stalks. I have seen both 8mm and 10mm O.D. stalks. It would be very easy to modify in Tinkercad if you need bigger or smaller. These should fit both front and rear mounting holes.

Note: LED signals are NOT plug-and-play on the Gen 2 KLR if you replace all 4. You will need an LED-compatible flasher (or LED signals that have their own flasher built-in) and you will need to install resistors or diodes to prevent the "hazard flashing" where all 4 signals light for either turn signal.

Use at your own risk!