18mm Vortex Rocket remix Estes C

Just adding some slight mods to HAL 9000's design. But it's about 85% the same as his. Key differences 1. Deleted the connecting sections and built separate connectors. That way if the fit is too tight or too loose, all you need to do is reprint the connectors, not the whole section. The one for the nose cone has a parachute mounting point. 2. I added a baffle inside the fin section. Hopefully won't need parachute wadding 3. Shortened up the motor mount area so the motor pokes out about 5mm past the end of the rocket. Giving you a little room to grab it with your fingers.

You will likely need supports for the fin section and just a small support for the body section.

Otherwise it's all the same. I did flip the objects to their proper printing position. I print my nosecones standing up. HAL recommended printing the nosecone on it's side. Up to you!

Thanks HAL 9000 I have now printed this but still haven't flown it yet.