Air75 / Air75 II Battery Crash Protector PLA/PETG

A crash-protection battery mount designed for Air75 and Air75 II whoop frames.

This mount helps protect your LiHV battery during crashes by keeping it elevated and shielded, reducing direct impact on the pack.

It has been tested on Air75 II and is designed to also fit the original Air75 frame, since both share the same 75mm layout.

🔋 Battery Compatibility •    Fits 480mAh and 580mAh batteries perfectly •    680mAh not tested yet

🔒 Fit & Installation •    Designed as a very snug fit to keep the battery secure •    You can use it without glue, but: •    Test the fit first •    Then optionally super glue it if you want maximum security

⚙️ Versions Included

There are 2 versions included: 1.    With hole •    Easier battery removal (push from the bottom) •    Weight: ~1.99g

2.    Without hole •    Weight: ~2.7g

🛡️ Safety & Clearance •    Does NOT touch or interfere with the AIO or electronics •    No pressure on wiring or components •    Fully safe for normal use

⚠️ Weight Note

Yes, it’s a bit on the heavier side for a tiny whoop.

If there’s enough interest, I’ll work on a lighter revision while trying to keep the same strength and protection.

Compatibility:

Designed around the Air75 II, but should also work with the original Air75 due to similar dimensions. Fit may vary slightly depending on frame tolerances.

If you try it, let me know how it fits, especially with different battery sizes or on the original Air75.