RatRig V-Core 4 Filament Guide, SFS v1, Orbiter Feeder Motor

Disclaimer: This model has only been tested on a V-Core 4 500 Hybrid. This has not been tested on an IDEX setup and may not clear a dual head setup. This has not been tested on a 300 or 400 sized machine. After I convert to IDEX I will update accordingly.

The V-Core 4 500 is a beast of a machine, and benefitted greatly from a smart runout sensor and a feeder motor to utilize larger spools and help mitigate large print failures. These brackets span over the belts and maintain the stock filament paths. They should be usable on any 3030 series extrusion.

Uses the m6 x 12 mm screw and t-nut that held the original filament guide on. Uses two m3 threaded inserts and 2x M3x8 Cap Head Screws. The SFS mounts with the screws used to hold the standard back panel on.