Peach - Fidget toy

Hi, everyone, I made a peach fidget toy.

This model is not universal and may not fit your keyboard switches, before printing them in large quantities first print one piece and test for compatibility with your keyboard switches.

You will need keyboard switches and glue to assemble this model. The keyboard switches you need to make your model click.

Instruction:

Before printing the model, don't forget to set up the supports as shown in the photo.

To make your clickers click you need the keyboard switches

Don't forget to cut the pins before installation

Cut off the side walls

After printing remove the supports

Assemble all parts in order as shown in the photo. Don't forget to use glue for assembly (I use two-component epoxy glue).

________________________________________________________

Don't forget to share your prints

________________________________________________________

If you have any problems, please email me

________________________________________________________

All my models are for personal use only

________________________________________________________

Don't forget to subscribe to me

________________________________________________________

All of my designs are protected by copyright law. Your purchase does not authorize you to distribute or sell digital files or printed models of my designs without my express written permission To legally sell my flexi toy designs, please visit my Patreon page: http://patreon.com/IX_Stvdio

3D printing settings

Layer height: 0.16 mm

Walls: 2

Infill: 15%

Supports: +