Self Watering Tripot

This is a self watering plant pot setup made for self watering using a cotton wick.

Printing a full usable model with the water reservoir and the three pots as in the image will use about 800 grams of filament in total.

The system is adaptive, meaning you can use any configuration of compatible pots, which will slide along the reservoir freely.

Included are the three pots seen in the picture, which can be used in any assortment of heights, as well as wide pots that take up the full width of the reservoir.

To guarantee the print stays waterproof I would recommend sealing it in some way, I have used a UV epoxy on the inside of my reservoir.

Check out my other pots:

Self Watering Large Pot

Self Watering Slightly Smaller Pot