Halloween Black Cat & Pumpkin Openwork Bookmark

0.2mm layer, 2 walls, 15% infill Print Profile Description

0.20 mm layer height using a 0.4 mm nozzle.

This profile is set up for the detailed openwork construction and multicolour Halloween design.

The profile uses the Classic wall generator, aligned seam positioning, Smart Scarf Seam and the line-width and precision settings used for the photographed print.

Just use my supplied settings and you’ll get the print exactly as shown.

Print Details

Model: Halloween Black Cat & Pumpkin Bookmark Size: 200 × 50 × 1 mm Nozzle: 0.4 mm Layer height: 0.20 mm Initial layer height: 0.20 mm Wall generator: Classic Wall order: Inner/Outer Ironing: No ironing Seam: Aligned Smart Scarf Seam: Enabled Scarf angle threshold: 155° Scarf steps: 10 Bridge flow: 1 Elephant foot compensation: 0.15 mm Resolution: 0.012 mm Slice gap closing radius: 0.049 mm Arc fitting: Enabled X-Y hole compensation: 0 mm X-Y contour compensation: 0 mm Smooth speed discontinuity area: Enabled Smooth coefficient: 150

Line Widths

Default: 0.42 mm Initial layer: 0.50 mm Outer wall: 0.42 mm Inner wall: 0.45 mm Top surface: 0.42 mm Sparse infill: 0.45 mm Internal solid infill: 0.42 mm Support: 0.42 mm

Print Notes

Print the bookmark flat on the build plate.

The model contains fine openwork sections, so good first-layer adhesion is important. Make sure the plate is clean before starting the print.

The finished model is only 1 mm thick , keeping it suitable for use inside a book without adding unnecessary bulk.

No ironing is required.

The photographs show the finished multicolour print using black as the main structural colour, with orange and red details.

For the closest result to the photographs, use the supplied profile without changing the precision or line-width settings.