Cherry Blossom

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size. You can adjust the X and Y but Z must remain the same. You may print at higher layer heights below the Min Depth of 0.48mm Actual Depth is 2.2mm

Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA BambuLab Basic Gray Transmission Distance: 2 PLA BambuLab Basic Jade White Transmission Distance: 5 PLA BambuLab Basic Pink Transmission Distance: 8 This print uses 5 unique filaments. Substitute as needed.

Swap Instructions: Start with Black At layer #8 (0.72mm) swap to Blue Gray At layer #12 (1.04mm) swap to Gray At layer #13 (1.12mm) swap to Jade White At layer #17 (1.44mm) swap to Black At layer #19 (1.6mm) swap to Pink for the rest.

Boost Me Got a Boost to spare? Every little bit helps the motivation. Thank you!

Membership Want to go commercial or maybe just show some love? Consider signing up to show support!