Laptop Stand - Macbook Pro (Early 2011 - 13 inch)

Simple angled laptop stand for my Macbook Pro. Wanted a sharper angle to take up less deskroom. Will likely support other laptops -- the gap between vertical supports is 17mm.

Inspired by this design but rebuilt in Tinkercad. I wanted to round out the leading edges and provide additional support to the rear support. Slimmed and widened the base.

Print instructions

Category: Computer Print Settings

Printer Brand: Prusa

Printer: i3 MK3

Rafts: No

Supports: No

Resolution: .3

Infill: 10%

Notes:

Used printer settings inspired by this Makers Muse https://www.youtube.com/watch?v=3kW9SnK4LKc video.

In case it's not obvious, you'll need to print two of these :) Each took about 1.5hr using 'Stupid Fast' settings.