Cardin S449 remote 4 button/new model case for sun visor

So my old S449 remote broke, for which I made and used this:

New S449 remote with four buttons is different from size. So I made from scratch new case. Also added this time a clip in front as the case starts to sag over time. This case should stay neatly at the sun visor.

The design of the clips are on purpose like this. When you completely unfold the sun visor then you need to move the case a bit down or it will prevent completely unfolding.

When printing, print it at the side (see 3mf file) with supports only from the bed. I did not use organic supports which made the inside of the left side not clean. But after cleaning with a knife it is good enough. If you use organic supports, it should also support left side.

The case is designed to snug fit the remote in it. Therefore the cover is optional but it is a good safety to prevent the remote falling out.