Adventure Force Axis Pro Low Profile Mag Switch

I prefer to place my hand right under the BCAR and I found that the original handle got in the way so I came up with this low profile switch.

Provides more tactile feedback with its two position design compared to the original free spinning handle.

Find more Axis Pro Accessories here https://www.printables.com/@Ghostmanta_3143708/collections/3279015

Recommended Tools

- Phillips Screw Driver

- Utility Knife/Cutting Tool

- 7mm Drill Bit (Optional)

Installation Guide

Begin by removing the four screws located in the original handle and remove the handle from the blaster.

Once the outer handle is removed, a inner orange tube will be exposed. Measure, mark and cut the orange tube so only 15mm is exposed. I used a fresh utility blade and some patience to cut through but a cutting tool will make quick work of it.

Slide the new switch over the shortened exposed orange tube. Mine friction fit on tightly and didn't need the pin. If you choose to use the pin, you will need to drill a 7mm hole.

Filament

- Elegoo PLA Plus (Grey) https://us.elegoo.com/products/elegoo-pla-plus-3d-printer-filament-1-75mm-colored-1kg

Ways to Support Future Uploads

- Buymeacoffee https://buymeacoffee.com/brendanramk

- Visit my store section https://www.printables.com/@Ghostmanta_3143708/store

- A simple like, follow or download :)