Fake GoPro 8 WITH PRONGS + Session

Inspired by and to get the GoPro 8 non-prong mount:

https://www.thingiverse.com/thing:4382722

For when you don't want to risk your GoPro on your quads.

Set your slicer to do a pause or filament change at the top of the empty cavities. Load in:

GoPro 8 - 36 pennies

Session - 20 Pennies

To get the correct weight, weigh the pennies that will be used and then make up the difference for the target weight with the filament. Cura was fairly accurate with the "basic" default profile. I used 3 perimeters, and adjusted the infill. See screenshots.

For example - the session is ~73g. The pennies are 50g. Adjust the infill until the filament used is estimated around 23g. Err on the side of 1-2 grams heavier if desired.

Print Settings

Rafts:

No

Supports: No

Resolution:

200

Infill: 20

Filament: PolyMaker PLA

Category: R/C Vehicles