Voron V0 TopHat Pi Cam

This is a remix of SNEAKS great work! I'm using that case with the original piCam V2 and also with a clone from amazon (you maybe have to modifiy the lense hole of the front cover) with different printers.

the back of the cam case is a little bit lower than the original one, also the sphere hole is smaller. You will need a M3x16mm screw to mount it with a tophat corner. So it will replace the origin M3x12 screw.

I sticked the 50cm long cam cable with double sided VHB tape directly to the top panel. With the shown cable route it's possible to connect the cam directly to pi at the back, without twisting and without touching the XY belts.