Wyze Camera Mount for Prusa I3 MK3S+

This is a remix to an existing camera mount. The remix adjusts the camera height and spacing from the print bed for better alignment with the first layer and to allow clearance for side drawers (the side drawers I've printed are: https://www.thingiverse.com/thing:3124672). It is mounted to the available bold hole in the E-Stage using an M3x20 bolt (you can use one of the spares that came with your printer). This camera mount also allows for the camera's full articulation and can be slid in from either end of the mount.

It is designed to be print in place without supports. I used Esun Orange PLA - but found it to be not as vibrant as the Prusa Orange of the printer. I didn't design in any cable management clips but there are plenty of surfaces on this model to include a tie wrap sticky.

I hope you like it!