xTool F1 Exhaust Duct Adapter and Internal Fan Spacer (4in)

I wanted to connect my xTool F1 to the inline exhaust system I already had in my shop. I wasn't able to locate one specifically for the F1 so I went ahead and designed and printed one.

This adapter connects to the xTool F1 and allows a connection to a 4in exhaust hose and features a lip to help secure the hose to the adapter.

I printed it in PETG but I think PLA would preform just as well in a stationary environment.

Installation

- Remove and disconnect the internal fan tucking the wire out of the way (optionally, you can cover the connector with electrical tape) - Replace with the Internal Fan Spacer - Install the Flange Duct Adapter using the same screws you removed in Step 1 - Disable the internal fan warning in XCS Inspiration for this model came from @GizmoGoody with a similar adapter for the xTool P2 shared here: https://www.printables.com/model/883905-parametric-xtool-p2-exhaust-duct-adapter-and-inter

Thank you!

NOTE: This is for the original xTool F1 NOT the F1 Ultra