FPV Mark4 V2 3D Models: Mounts, Plates and TPU Parts

«FPV Mark4 V2 3D Models: Mounts, Plates and TPU Parts»

The models fall into a few groups. Structural pieces such as side plates and arm holders replace or reinforce parts of the frame, while mounts position a camera, VTX, GPS module or antenna on the frame. TPU covers and full kits protect electronics and tidy up wiring, and a separate group covers goggles and ground-station accessories such as battery holders and head trackers.

Sizes vary widely, from small frames to large long-range builds, so check the arm spacing and the scale stated on the model page before printing. Look at the number of parts, how they assemble, whether the author lists supports, and which material and settings are recommended — TPU for parts that flex or absorb vibration, a stiffer filament for plates. Photos of real prints and the mounting hole spacing help you judge whether a part will line up with your hardware.

To narrow the search, try related terms: frame name with the size in inches, camera model, VTX or receiver type, GPS module, antenna connector, or the words side plate, arm holder, camera mount, antenna mount and TPU kit. Combining the frame name with a specific component usually returns fewer, more relevant results than the frame name alone.